SimpleComTools COM1000 Guía de usuario descargar pdf (Pagina 67)

Raven CDMA User Guide for Verizon, version 2.23 61

Basic Commands

These commands are common to most communication devices using AT Com-

mands.

TABLE 3. Basic Commands (common AT commands)

Command Parameters Details

+++

The "+" is ASCII 0x2B.

none AT Escape sequence.

Not proceeded by AT.

If the Raven is in a data mode (any mode other than

PassThru), this command causes the modem to re-enter

AT command mode.

There must be an idle time (set by S50) on the serial port

before and after this command.

The detection of +++ is disabled if DAE=1.

A/ none Re-execute last command.

Not proceeded by AT.

A none Answer - manual

DAE=n n=0 or 1 Disable AT Escape Sequence detection.

0 : Enable +++ AT escape sequence detection.

1 : Disable +++ AT escape sequence detection.

En n=0 or 1 Toggle AT command echo mode.

0 : Echo Off

1 : Echo On

Hn n=1 Hang-Up Command.

1: Hang-up

Note: With an AT telnet connection, this command will

terminate the host data mode and return the Raven to an

AT mode.

O none Online (Remote): Causes the Raven to go from Com-

mand State to data state.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 114 115

Sin comentarios

SimpleComTools COM1000 Guía de usuario Pagina 67